Is Light Partition Board Used For Ceiling Installation?

The light partition board shall be installed in a free state, and shall be fixed from the middle of the board to the periphery of the board. Regulations on the distance between the plate screw and the plate edge: the paper edge should be 10-15mm, the cutting edge should be 15-20mm, and the distance between the solid wall panel pressing plate screw and the plate edge should be 8-15mm. The nail distance around the plate should be 150-170mm, and the nail distance in the plate should not be greater than 200mm.

When installing the double-layer solid light partition board, the joints of the upper and lower (inner and outer) layers shall be staggered, and the joints on one keel are not allowed. The screw head should be slightly embedded in the board surface, and the paper surface shall not be damaged. The nail holes shall be treated with rust prevention and smoothed with putty.

Lightweight partition board is a new type of building material, which is applicable to partition the non load-bearing parts inside the larger house, so that the house can be rebuilt without rebuilding the land. The partition board is very light in weight. It also has the characteristics of fire prevention, waterproof, sound insulation and re plasticity. It can be directly painted or even pasted with porcelain chips. It saves labor and labor. It is a very good new building material. The partition board is made of non combustible materials through special process. It has high strength and small floor area, which can greatly reduce the problem of reducing the practical space caused by construction. It can be said that it is a new energy-saving partition board with high cost performance, economic and practical, and does not affect the beauty. It is your building construction material.